Cisco ONS 15454 DWDM - Figure

2-32
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 2 Connect the PC and Log into the GUI
DLP-G53 Configure the CTC Alerts Dialog Box for Automatic Popup
Step 6 From the File menu, choose Exit.
Step 7 In the confirmation dialog box, click Ye s .
Step 8 Return to your originating procedure (NTP).
DLP-G53 Configure the CTC Alerts Dialog Box for Automatic Popup
Step 1 Click the CTC Alerts toolbar icon.
Step 2 In the CTC Alerts dialog box, choose one of the following:
• All alerts—Sets the CTC Alerts dialog box to open automatically for all notifications.
• Error alerts only—Sets the CTC Alerts dialog box to open automatically for circuit deletion errors
only.
• Never—Sets the CTC Alerts dialog box to never open automatically.
Step 3 Click Close.
Step 4 Return to your originating procedure (NTP).
Purpose This task sets up the CTC Alerts dialog box to open for all alerts, for circuit
deletion errors only, or never. The CTC Alerts dialog box displays network
disconnection, Send-PDIP inconsistency, circuit deletion status, condition
retrieval errors, and software download failure.
Too ls None
Prerequisite Procedures DLP-G46 Log into CTC, page 2-25
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher