Cisco ONS 15454 DWDM - Figure 19-5 Facility Loopback Indicator; Table 19-8 Node View Tabs and Subtabs; Node View Card Shortcuts

19-10
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
August 2005
Chapter 19 CTC Operation Reference
19.5.1 Node View
Figure 19-5 Facility Loopback Indicator
19.5.1.2 Node View Card Shortcuts
If you move your mouse over cards in the graphic, popups display additional information about the card
including the card type; the card status (active or standby); the type of alarm, such as Critical, Major, or
Minor (if any); the alarm profile used by the card; and for transponder (TXP) or muxponder (MXP)
cards, the wavelength of the dense wavelength division multiplexing (DWDM) port. Right-click a card
to reveal a shortcut menu, which you can use to open, reset, delete, or change a card. Right-click a slot
to preprovision a card (that is, provision a slot before installing the card).
19.5.1.3 Node View Tabs
Table 19-8 lists the tabs and subtabs available in the node view.
Table 19-8 Node View Tabs and Subtabs
Tab Description Subtabs
Alarms Lists current alarms (CR, MJ, MN) for the node
and updates them in real time.
—
Conditions Displays a list of standing conditions on the
node.
—
History Provides a history of node alarms including date,
type, and severity of each alarm. The Session
subtab displays alarms and events for the current
session. The Node subtab displays alarms and
events retrieved from a fixed-size log on the
node.
Session, Node
Circuits Creates, deletes, edits, and maps circuits. —
Provisioning Provisions the ONS 15454 node. General, Ether Bridge, Network,
Protection, BLSR, Security, SNMP,
Comm Channels, Timing, Alarm
Profiles, Defaults, UCP, WDM-ANS
Inventory Provides inventory information (part number,
serial number, Common Language Equipment
Identification [CLEI] codes) for cards installed
in the node. Allows you to delete and reset cards
and change the card service state.
—
Maintenance Performs maintenance tasks for the node. Database, Ether Bridge, Protection,
BLSR (ANSI), MS-SPRing (ETSI),
Software, Cross-Connect, Overhead
XConnect, Diagnostic, Timing,
Audit, Routing Table, RIP Routing
Table, Test Access, DWDM