2-24
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 2 Connect the PC and Log into the GUI
NTP-G21 Log into the ONS 15454 GUI
NTP-G21 Log into the ONS 15454 GUI
Step 1 Complete the “DLP-G46 Log into CTC” task on page 2-25.
Note For information about navigating in CTC, see Appendix A, “CTC Information and Shortcuts.”
Step 2 As needed, complete the “DLP-G48 Create Login Node Groups” task on page 2-28. Login node groups
allow you to manage nodes that are not connected to the login node through a data communications
channel (DCC).
Step 3 As needed, complete the “DLP-G49 Add a Node to the Current Session or Login Group” task on
page 2-30.
Step 4 As needed, complete the “DLP-G50 Delete a Node from the Current Session or Login Group” task on
page 2-30.
Step 5 As needed, complete the “DLP-G51 Delete a Node from a Specified Login Node Group” task on
page 2-31.
Step 6 As needed, complete the “DLP-G52 Change the JRE Version” task on page 2-31.
Step 7 As needed, complete the “DLP-G53 Configure the CTC Alerts Dialog Box for Automatic Popup” task
on page 2-32.
Stop. You have completed this procedure.
Purpose This procedure logs into CTC, the graphical user interface (GUI) software
used to manage the ONS 15454. This procedure includes optional node
login tasks.
Tools/Equipment None
Prerequisite Procedures NTP-G17 Set Up Computer for CTC, page 2-2
One of the following procedures:
• NTP-G18 Set Up CTC Computer for Local Craft Connection to the
ONS 15454, page 2-9
• NTP-G19 Set Up a CTC Computer for a Corporate LAN Connection
to the ONS 15454, page 2-21
• NTP-G20 Set Up a Remote Access Connection to the ONS 15454,
page 2-23
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Retrieve or higher
To Next Page
Loading...
