9-24
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 9 Monitor Performance
DLP-G147 View Payload PM Parameters
Figure 9-7 Viewing Payload Performance Monitoring Information
Step 3
Go to any of the tabs, subtabs, or ports (found in the Ports drop-down list where available) for the card
where you want to view the payload PM parameters by clicking on the desired subtab, and choosing the
port from the Port drop-down list.
Step 4 View the PM parameter names that appear in the Param column of the Current Values and History PM
tabs The PM parameter values appear in the Curr (current), and Prev-n (previous) columns. For PM
parameter definitions, refer to the “Performance Monitoring” chapter in the Cisco ONS 15454
Troubleshooting Guide or the Cisco ONS 15454 SDH Troubleshooting Guide.
Note The payload PMs for data parameters can be viewed only after creating a pluggable port module
(PPM). See the “NTP-G128 Manage Pluggable Port Modules” procedure on page 5-2 for more
information about PPMs.
Note The PM parameters that appear depend on the data payload and framing type provisioned on the
port. Unframed data payloads such as Enterprise System Connection (ESCON), DV6000,
DSI/D1 video, and high-definition television (HDTV) do not provide payload PM information.
The PM parameters that appear also depend on the PPM payload configured. The TXP_MR_10E
card supports three payloads, the MXP_2.5G_10G and MXP_2.5G_10E cards support the
OC48/STM16 payload, and the MXP_MR_2.5G and MXPP_MR_2.5G cards support the 1G FC,
2G FC, 1G FICON, 2G FICON, and 1GE payloads.
96977v
Directions
radio buttons
Performance
tab
Payload PM
tab
Card View
Intervals
radio buttons
Help
button
Clear
button
Baseline
button
Auto-refresh
menu
Refresh
button
Signal-type
port menu
To Next Page
Loading...
