Cisco ONS 15454 DWDM - DLP- G236 Change Client Line Settings for MXP_MR_2.5 G and MXPP_MR_2.5 G Cards

5-67
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 5 Provision Transponder and Muxponder Cards
DLP-G236 Change Client Line Settings for MXP_MR_2.5G and MXPP_MR_2.5G Cards
DLP-G236 Change Client Line Settings for MXP_MR_2.5G and MXPP_MR_2.5G
Cards
Step 1 In node view, double-click the MXP_MR_2.5G or MXPP_MR_2.5G card where you want to change the
line settings.
Step 2 Click the Provisioning > Line > Client tabs. Tabs and parameter selections vary according to PPM
provisioning.
Step 3 Modify any of the settings for the client service tab as described in Table 5-42.
Purpose This task changes the line settings for MXP_MR_2.5G and
MXPP_MR_2.5G muxponder cards.
Tools/Equipment None
Prerequisite Procedures DLP-G46 Log into CTC, page 2-25
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
Table 5-42 MXP_MR_2.5G and MXPP_MR_2.5G Muxponder Card Client Service Tab Settings
Parameter Description Options
Port # (Display only) Port number.
• 1
• 2
Port Name The user can assign a logical name for each of the
ports shown by filling in this field.
User-defined. Name can be up to 32 alphanumeric/
special characters. Blank by default.
See the “DLP-G104 Assign a Name to a Port” task on
page 7-10.
Admin State Sets the port service state unless network
conditions prevent the change. For more
information about administrative states, see
Appendix C, “DWDM Administrative and Service
States.”
• IS (ANSI) or Unlocked (ETSI)
• IS,AINS (ANSI) or Unlocked,automaticInService
(ETSI)
• OOS,DSBLD (ANSI) or Locked,disabled (ETSI)
• OOS,MT (ANSI) or Locked,maintenance (ETSI)
Service State Identifies the autonomously generated state that
gives the overall condition of the port. Service
states appear in the format: Primary State-Primary
State Qualifier, Secondary State. For more
information about service states, see Appendix C,
“DWDM Administrative and Service States.”
• IS-NR (ANSI) or Unlocked-enabled (ETSI)
• OOS-AU,AINS (ANSI) or Unlocked-disabled,
automaticInService (ETSI)
• OOS-MA,DSBLD (ANSI) or
Locked-enabled,disabled (ETSI)
• OOS-MA,MT (ANSI) or
Locked-enabled,maintenance (ETSI)