Cisco ONS 15454 DWDM - NTP- G89 Change SNMP Settings

10-61
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 10 Manage the Node
NTP-G89 Change SNMP Settings
NTP-G89 Change SNMP Settings
Step 1 Complete the “DLP-G46 Log into CTC” task on page 2-25. If you are already logged in, continue with
Step 2.
Step 2 Complete the “NTP-G103 Back Up the Database” procedure on page 13-2.
Step 3 Perform any of the following tasks as needed:
• DLP-G197 Modify SNMP Trap Destinations, page 10-61
• DLP-G198 Delete SNMP Trap Destinations, page 10-62
Step 4 Complete the “NTP-G103 Back Up the Database” procedure on page 13-2.
Stop. You have completed this procedure.
DLP-G197 Modify SNMP Trap Destinations
Step 1 In node view, click the Provisioning > SNMP tabs.
Step 2 Select a trap from the Trap Destinations area.
For a description of SNMP traps, refer to the Cisco ONS 15454 Troubleshooting Guide or the
Cisco ONS 15454 SDH Troubleshooting Guide.
Step 3 Highlight the Destination row field entry in the Community column and change the entry to another valid
community name.
The community name is a form of authentication and access control. The community name assigned to
the ONS 15454 is case-sensitive and must match the community name of the network management
system (NMS).
Step 4 If needed, modify the UDP port in the UDP Port field. The default UDP port for SNMP is 162.
Purpose This procedure modifies the SNMP settings for the ONS 15454.
Tools/Equipment None
Prerequisite Procedures NTP-G28 Set Up SNMP, page 3-35
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
Purpose This task modifies the SNMP trap destinations on an ONS 15454 including
community name, default User Datagram Protocol (UDP) port, SNMP trap
version, and maximum traps per second.
Tools/Equipment None
Prerequisite Procedures DLP-G46 Log into CTC, page 2-25
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher