11-39
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 11 Change DWDM Card Settings
DLP-G214 Change Optical Line Parameters for the 32WSS Card
DLP-G214 Change Optical Line Parameters for the 32WSS Card
Step 1 In node view, double-click the 32WSS card where you want to change the optical line parameter settings.
Step 2 Click the Provisioning > Optical Line > Parameters tab.
Step 3 Modify any of the settings described in Table 11-23. The provisionable parameters are listed in the
options column in the table.
Purpose This task changes the optical line parameter settings for the 32WSS card.
Tools/Equipment None
Prerequisite Procedures DLP-G46 Log into CTC, page 2-25
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
Table 11-23 32WSS Optical Line Parameter Settings
Parameter Description Options
Port (Display only) Port designation information. See
“16.7.6 32WSS Card” section on page 16-76 for
more information.
—
Port Name Allows you to assign a logical name for each of the
ports shown.
User-defined. Name can be up to 32 alphanumeric/
special characters. Blank by default. Double-click,
enter the name, and press Enter.
See the “DLP-G104 Assign a Name to a Port” task on
page 7-10.
Admin State Sets the port service state unless network conditions
prevent the change. For more information about
administrative states, see Appendix C, “DWDM
Administrative and Service States.”
From the drop-down list, choose one of the following:
• IS/Unlocked
• IS,AINS/Unlocked,automaticInService
• OOS,DSBLD/Locked,disabled
• OOS,MT/Locked,maintenance
Service State (Display only) Identifies the autonomously
generated state that gives the overall condition of the
port. Service states appear in the format: Primary
State-Primary State Qualifier, Secondary State. For
more information about service states, see
Appendix C, “DWDM Administrative and Service
States.”
• IS-NR/Unlocked-enabled
• OOS-AU,AINS/Unlocked-disabled,
automaticInService
• OOS-MA,DSBLD/Locked-enabled,disabled
• OOS-MA,MT/Locked-enabled,maintenance
Line
Direction
(Display only) Shows the line direction associated
with the optical signal that passes through the port.
This parameter is automatically configured during
ANS.
From the drop-down list, choose one of the following:
• West to East
• East to West
To Next Page
Loading...
