Cisco ONS 15454 DWDM - DLP- G195 Log out a User on a Single Node

10-53
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 10 Manage the Node
DLP-G195 Log Out a User on a Single Node
Note CTC will allow you to delete other Superusers if one Superuser remains. For example, you can delete
the CISCO15 user if you have created another Superuser. Use this option with caution.
Step 1 From the View menu, choose Go to Network View.
Step 2 Click the Provisioning > Security tabs. Highlight the name of the user you want to delete.
Step 3 Click Delete. The Delete User dialog box appears.
Step 4 In the Select Applicable Nodes area, uncheck any nodes where you do not want to delete this user.
Step 5 Click OK. A User Deletion Results confirmation dialog box appears.
Step 6 Click OK to acknowledge the changes. Confirm that the changes appear; if not, repeat the task.
Step 7 Return to your originating procedure (NTP).
DLP-G195 Log Out a User on a Single Node
Step 1 In node view, click the Provisioning > Security > Active Logins tabs.
Step 2 Choose the user that you want to log out and click Logout.
Step 3 In the Logout User dialog box, check Lockout before Logout if you want to lock the user out. This
prevents the user from logging in after logout based on user lockout parameters provisioned in the Policy
tab. A manual unlock by a Superuser is required, or else the user is locked out for the amount of time
specified in the Lockout Duration field. See the “DLP-G188 Change Security Policy for a Single Node”
task on page 10-46 for more information.
Step 4 Click OK.
Step 5 Click OK to confirm the logout.
Step 6 Return to your originating procedure (NTP).
Purpose This task logs out a user from a single node.
Tools/Equipment None
Prerequisite Procedures DLP-G46 Log into CTC, page 2-25
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Superuser