Cisco ONS 15454 DWDM - B.5.4 MXP_MR_2.5 G and MXPP_MR_2.5 G Card Specifications

B-41
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
December 2006
Appendix B Hardware Specifications
B.5.4 MXP_MR_2.5G and MXPP_MR_2.5G Card Specifications
• Transmitter (client side)
– Maximum transmitter output power: –1 dBm
– Minimum transmitter output power: –6 dBm
– Center wavelength: 1290 to 1330 nm
– Nominal wavelength: 1310 nm
– Transmitter: DFB laser
• Receiver (client side)
– Maximum receiver level: –1 dBm at BER 1 * 10 exp – 12
– Minimum receiver level: –14 dBm at BER 1 * 10 exp – 12
– Receiver: APD
– Link loss budget: 8 dB minimum, at BER = 1 * 10 exp – 12
– Receiver input wavelength range: 1290 to 1605 nm
• Environmental
– Operating temperature: –5 to +45 degrees Celsius (+23 to +113 degrees Fahrenheit)
– Operating humidity: 5 to 95 percent, noncondensing
– Power consumption: 35.00 W, 0.73 A at –48 V, 119.5 BTU/hr
• Dimensions
– Height: 12.650 in. (321.3 mm)
– Width: 0.716 in. (18.2 mm)
– Depth: 9.000 in. (228.6 mm)
– Depth with backplane connector: 9.250 in. (235 mm)
– Weight not including clam shell: 3.1 lb (1.3 kg)
B.5.4 MXP_MR_2.5G and MXPP_MR_2.5G Card Specifications
The MXP_MR_2.5G and MXPP_MR_2.5G cards have the following specifications:
• Payload configuration
– FC1G—Fiber Channel 1.06 Gbps
– FC2G—Fiber Channel 2.125 Gbps
– FICON1G—Fiber CON 1.06 Gbps (IBM signal)
– FICON2G—Fiber CON 2.125 Gbps (IBM signal)
– ONE_GE—One Gigabit Ethernet 1.125 Gbps
– Mixed configurations up to maximum line rate (for example, if you have a port configured for
2G FC, you cannot use another port at the same time)
• Client ports: 8x SFP
• Performance monitoring (PM) for all interfaces
• Buffer-to-buffer credit management for distance extension
• Line (trunk side)