Cisco ONS 15454 DWDM - DLP- G128 Disable Alarm Filtering

8-28
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 8 Manage Alarms
DLP-G128 Disable Alarm Filtering
Step 7 Return to your originating procedure (NTP).
DLP-G128 Disable Alarm Filtering
Step 1 At node, network, or card view, click the Alarms tab.
Step 2 Click the Filter tool icon on the right side of the bottom toolbar.
Note The Filter tool icon differs from the Filter button at the bottom left of the screen.
Alarm filtering is enabled if the tool is indented and disabled if the tool is raised (not selected).
Step 3 If you want alarm filtering disabled when you view conditions, click the Conditions tab and click the
Filter tool.
Step 4 If you want alarm filtering disabled when you view alarm history, click the History tab and click the
Filter tool.
Step 5 Return to your originating procedure (NTP).
Purpose This task turns off specialized alarm filtering in all network nodes so that
all severities are reported in CTC.
Tools/Equipment None
Prerequisite Procedures DLP-G126 Enable Alarm Filtering, page 8-25
DLP-G46 Log into CTC, page 2-25
Required/As Needed As needed
Onsite/Remote
Onsite or remote
Security Level
Retrieve or higher