19-14
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
August 2005
Chapter 19 CTC Operation Reference
19.6 TCC2/TCC2P Card Reset
19.6 TCC2/TCC2P Card Reset
You can reset the ONS 15454 TCC2/TCC2P card by using CTC (a soft reset) or by physically reseating
a TCC2/TCC2P card (a hard reset). A soft reset reboots the TCC2/TCC2P card and reloads the operating
system and the application software. Additionally, a hard reset temporarily removes power from the
TCC2/TCC2P card and clears all buffer memory.
You can apply a soft reset from CTC to either an active or standby TCC2/TCC2P card without affecting
traffic. If you need to perform a hard reset on an active TCC2/TCC2P card, put the TCC2/TCC2P card
into standby mode first by performing a soft reset.
Note When a CTC reset is performed on an active TCC2/TCC2P card, the AIC-I card goes through an
initialization process and also resets because it is controlled by the active TCC2/TCC2P card.
Provisioning Provisions an ONS 15454 card. DS-N and OC-N cards: Line, Line
Thresholds (different threshold
options are available for DS-N and
OC-N cards), Elect Path Thresholds,
SONET Thresholds, SONET STS,
and Alarm Profiles
TXP and MXP cards: Card, Line,
Line Thresholds, Optics Thresholds,
OTN, and Alarm Profiles
DWDM cards (subtabs depend on
card type): Optical Line, Optical
Chn, Optical Amplifier, Parameters,
Optics Thresholds, and Alarm
Profiles
Maintenance Performs maintenance tasks for the card. Loopback, Info, Protection, J1 Path
Trace, AINS Soak (options depend
on the card type), Automatic Laser
Shutdown
Performance Performs performance monitoring for the card. DS-N and OC-N cards: no subtabs
TXP and MXP cards: Optics PM,
Payload PM, OTN PM
DWDM cards (subtabs depend on
card type): Optical Line, Optical
Chn, Optical Amplifier Line, OC3
Line, Parameters, Optics Thresholds
Inventory Displays an Inventory screen of the ports (TXP
and MXP cards only).
—
Table 19-12 Card View Tabs and Subtabs (continued)
Tab Description Subtabs
To Next Page
Loading...
