EasyManua.ls Logo

Cisco ONS 15454 DWDM - Card View; Table 19-10 Node Status Shown in Network View; Table 19-11 Network View Tabs and Subtabs

Cisco ONS 15454 DWDM
1218 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
19-12
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
August 2005
Chapter 19 CTC Operation Reference
19.5.3 Card View
The color of a node in network view, shown in Table 19-10, indicates the node alarm status.
Table 19-11 lists the tabs and subtabs available in network view.
19.5.3 Card View
The card view provides information about individual ONS 15454 cards. Use this window to perform
card-specific maintenance and provisioning (Figure 19-7). A graphic showing the ports on the card is
shown in the graphic area. The status area displays the node name, slot, number of alarms, card type,
equipment type, card status (active or standby), card service state if the card is present, and port service
state (described in Table 19-7 on page 19-9). The information that appears and the actions you can
perform depend on the card. For more information about card service states, refer to Appendix C,
“DWDM Administrative and Service States.”
Table 19-10 Node Status Shown in Network View
Color Alarm Status
Green No alarms
Yellow Minor alarms
Orange Major alarms
Red Critical alarms
Gray with
Unknown#
Node initializing for the first time (CTC displays Unknown# because CTC has
not discovered the name of the node yet)
Table 19-11 Network View Tabs and Subtabs
Tab Description Subtabs
Alarms Lists current alarms (CR, MJ, MN) for the
network and updates them in real time.
Conditions Displays a list of standing conditions on the
network.
History Provides a history of network alarms including
date, type, and severity of each alarm.
Circuits Creates, deletes, edits, filters, and searches for
network circuits.
Provisioning Provisions security, alarm profiles,
bidirectional line switched rings (BLSRs)
(ANSI), multiplex section-shared protection
rings (MS-SPRing) (ETSI), and overhead
circuits.
Security, Alarm Profiles, BLSR
(ANSI), MS-SPRing (ETSI),
Overhead Circuits, Provisionable
Patchcords
Maintenance Displays the type of equipment and the status
of each node in the network; displays working
and protect software versions; and allows
software to be downloaded.
Software

Table of Contents

Other manuals for Cisco ONS 15454 DWDM

Related product manuals