Cisco ONS 15454 DWDM User Manual

1-25
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
August 2005
Chapter 1 Install the Shelf and Common Control Cards
DLP-G12 Remove the FMEC Cover
DLP-G12 Remove the FMEC Cover
Step 1 Unscrew the nut holding the ground wire to the shelf. Remove the nut and washer.
Step 2 Remove the ground wire from the left side of the shelf.
Step 3 Pull the right side of the hinge-locking spring (Figure 1-10).
Figure 1-10 Removing the ONS 15454 FMEC Cover
Step 4
Detach the cover from the pin of the hinge.
Step 5 Remove the cover carefully from the left pin of the hinge.
Step 6 Return to your originating procedure (NTP).
Purpose This task removes the FMEC cover in order to install the MIC-A/P and the
MIC-C/T/P.
Tools/Equipment Medium slot-head screwdriver
Prerequisite Procedures DLP-G11 Open the FMEC Cover, page 1-24
Required/As Needed As needed
Onsite/Remote Onsite
Security Level None
71087
F
A
N
F
A
IL
C
R
IT
M
A
J
M
IN
Pin hinge
FMEC cover
Hinge-locking
spring

Cisco ONS 15454 DWDM Specifications

General

Chassis Type	DWDM
Form Factor	Rack-mountable
Slots	17
Storage Temperature	-40 to 158°F (-40 to 70°C)
Relative Humidity	5% to 95% non-condensing
Power Supply	AC or DC
Cooling	Internal fans
Operating Temperature	23 to 104°F (-5 to 40°C)
Altitude	0 to 6500 ft (0 to 1981 m)
Safety Compliance	EN 60950-1
EMI Compliance	FCC Part 15