Cisco ONS 15454 DWDM - Viewing OTN FEC Performance Monitoring Information

9-26
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 9 Monitor Performance
DLP-G148 View OTN PM Parameters
Step 3 View the PM parameter names that appear in the Param column. The PM parameter values appear in the
Curr (current) and Prev-n (previous) columns. For PM parameter definitions, refer to the “Performance
Monitoring” chapter in the Cisco ONS 15454 Troubleshooting Guide or the Cisco ONS 15454 SDH
Troubleshooting Guide.
Step 4 Click the FEC PM tab (Figure 9-9).
Figure 9-9 Viewing OTN FEC Performance Monitoring Information
Step 5 View the PM parameter names that appear in the Param column. The PM parameter values appear in the
Curr (current) and Prev-n (previous) columns. For PM parameter definitions, refer to the “Performance
Monitoring” chapter in the Cisco ONS 15454 Troubleshooting Guide or the Cisco ONS 15454 SDH
Troubleshooting Guide.
Step 6 Return to your originating procedure (NTP).
96963
Directions
radio buttons
Performance
tab
OTN PM tab
FEC PM tab
Card View
Intervals
radio buttons
Help
button
Clear
button
Baseline
button
Auto-refresh
menu
Refresh
button
Signal-type
port menu