5-44
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 5 Provision Transponder and Muxponder Cards
DLP-G228 Change Line OTN Settings for MXP_2.5G_10G and MXP_2.5G_10E Cards
Step 8 Click Apply.
Step 9 Repeat Steps 7 and 8 to provision each additional client port. Otherwise, continue with Step 10.
Step 10 Return to your originating procedure (NTP).
DLP-G228 Change Line OTN Settings for MXP_2.5G_10G and MXP_2.5G_10E
Cards
Step 1 In node view, double-click the MXP_2.5G_10G or MXP_2.5G_10E card where you want to change the
line OTN settings.
Step 2 Click the Provisioning > OTN tabs, then choose one of the following subtabs: OTN Lines,
OTN G.709 Thresholds, FEC Thresholds, or Trail Trace Identifier.
Step 3 Modify any of the settings described in Tables 5-25 through 5-28.
Note You must modify Near End, and Far End independently; 15 Min and 1 Day independently; and
SM and PM independently. To do so, choose the appropriate radio button and click Refresh.
Table 5-25 describes the values on the Provisioning > OTN > OTN Lines tab.
Note In Table 5-25, some parameter tabs or values do not always apply to both the MXP_2.5G_10G
and the MXP_2.5G_10E card. When the tabs or values do not apply, they do not appear to the
user.
Table 5-24 MXP_2.5G_10G and MXP_2.5G_10E Card Client Interface Alarm Thresholds
Port Type
(by CTC)
Pluggable Port Module
(SFP)
Alarm RX
Power Low
Alarm RX
Power High
Alarm TX
Power Low
Alarm TX
Power High
OC-48 ONS-SE-2G-S1 -21 0 -13 0
15454-SFP-OC48-IR -21 3 -8 3
STM-16 ONS-SE-2G-S1 -21 0 -13 0
15454E-SFP-L.16.1 -21 3 -8 3
Purpose This task changes the line OTN settings for MXP_2.5G_10G and
MXP_2.5G_10E muxponder cards.
Tools/Equipment None
Prerequisite Procedures DLP-G46 Log into CTC, page 2-25
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
To Next Page
Loading...
