11-33
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 11 Change DWDM Card Settings
NTP-G93 Modify the 32WSS Thresholds and Settings
NTP-G93 Modify the 32WSS Thresholds and Settings
Step 1 Complete the “DLP-G46 Log into CTC” task on page 2-25 at the node where you want to change the
32WSS card settings. If you are already logged in, continue with Step 2.
Step 2 Complete the “NTP-G103 Back Up the Database” procedure on page 13-2.
Step 3 Perform any of the following tasks as needed:
• DLP-G212 Change Optical Channel Parameters for the 32WSS Card, page 11-33
• DLP-G213 Change the 32WSS Optical Channel Thresholds, page 11-36
Note To use the alarm profile tab, including creating alarm profiles and suppressing alarms, see
Chapter 8, “Manage Alarms.”
• DLP-G214 Change Optical Line Parameters for the 32WSS Card, page 11-39
• DLP-G215 Change the 32WSS Card Optical Line Thresholds, page 11-40
Step 4 Complete the “NTP-G103 Back Up the Database” procedure on page 13-2.
Stop. You have completed this procedure.
DLP-G212 Change Optical Channel Parameters for the 32WSS Card
Step 1 In node view, double-click the 32WSS card where you want to change the optical channel parameter
settings.
Step 2 Click the Provisioning > Optical Chn: Optical Connector tab for one of the four available groups of
eight optical channels.
Purpose This procedure changes the 32WSS card thresholds and settings.
Tools/Equipment None
Prerequisite Procedures NTP-G30 Install the DWDM Cards, page 3-39
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
Purpose This task changes the optical channel parameter settings for the 32WSS
card.
Tools/Equipment None
Prerequisite Procedures DLP-G46 Log into CTC, page 2-25
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
To Next Page
Loading...
