Cisco ONS 15454 DWDM - B.3.4 AEP Specifications (ANSI Only)

B-10
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
December 2006
Appendix B Hardware Specifications
B.3.4 AEP Specifications (ANSI only)
– Orderwire party line
– Dual tone, multifrequency (DTMF) signaling
• User data channel (UDC)
– Bit rate: 64 kbps, codirectional
– ITU-T G.703
– Input/output impedance: 120 ohm
– Termination: RJ-11 connectors
• Data communications channel (DCC)
– Bit rate: 576 kbps
– EIA/TIA-485/V11
– Input/output impedance: 120 ohm
– Termination: RJ-45 connectors
• ACC connection for additional alarm interfaces
– Connection to AEP
• Power monitoring alarming states:
– Power failure (0 to –38 VDC)
– Undervoltage (–38 to –40.5 VDC)
– Overvoltage (beyond –56.7 VDC)
• Environmental
– Operating temperature: –40 to 149 degrees Fahrenheit (–40 to +65 degrees Celsius)
– Operating humidity: 5 to 95 percent, noncondensing
– Power consumption (including AEP, if used): 8.00 W, 0.17 A, 27.3 BTU/hr
• Dimensions
– Height: 12.650 in. (321.3 mm)
– Width: 0.716 in. (18.2 mm)
– Depth: 9.000 in. (228.6 mm)
– Weight: 1.8 lb (0.82 kg)
B.3.4 AEP Specifications (ANSI only)
The AEP has the following specifications:
• Alarm inputs
– Number of inputs: 32
– Optocoupler isolated
– Label customer provisionable
– Severity customer provisionable
– Common 32 V output for all alarm inputs
– Each input limited to 2 mA