11-24
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 11 Change DWDM Card Settings
DLP-G208 Change Optical Line Settings for Multiplexer and Demultiplexer Cards
DLP-G208 Change Optical Line Settings for Multiplexer and Demultiplexer
Cards
Step 1 In node view, double-click the multiplexer or demultiplexer card where you want to change the optical
line settings.
Step 2 Click the Provisioning > Optical Line > Parameters tabs.
Step 3 Modify any of the settings described in Table 11-14. In the Options column, the SONET option is
followed by the SDH option. The provisionable parameters are listed in the options column in the table.
Purpose This task changes the optical line settings for 32MUX-O, 32DMX-O,
32DMX, and 4MD-xx.x multiplexer and demultiplexer cards.
Tools/Equipment None
Prerequisite Procedures DLP-G46 Log into CTC, page 2-25
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
Table 11-14 Multiplexer and Demultiplexer Card Optical Line Settings
Parameter Description Options
Port # (Display only) Displays the port number. Displays port number and TX or RX.
Port Name Provides the ability to assign the specified port a
name.
User-defined. Name can be up to 32 alphanumeric/
special characters. Blank by default. Double-click,
enter the name, and press Enter.
See the “DLP-G104 Assign a Name to a Port” task on
page 7-10.
Admin State Sets the port service state unless network
conditions prevent the change. For more
information about administrative states, see
Appendix C, “DWDM Administrative and Service
States.”
From the drop-down list, choose one of the following:
• IS/Unlocked
• IS,AINS/Unlocked,automaticInService
• OOS,DSBLD/Locked,disabled
• OOS,MT/Locked,maintenance
Line Direction Provides the ability to associate a card with the line
direction. CTC automatically configures the line
direction during node setup. To change this setting,
you must change the Cisco MetroPlanner site plan
and import it to the node.
From the drop-down list, choose one of the following:
• East to West
• West to East
Service State Identifies the autonomously generated state that
gives the overall condition of the port. Service
states appear in the format: Primary State-Primary
State Qualifier, Secondary State. For more
information about service states, see Appendix C,
“DWDM Administrative and Service States.”
Display only
• IS-NR/Unlocked-enabled
• OOS-AU,AINS/Unlocked-disabled,
automaticInService
• OOS-MA,DSBLD/Locked-enabled,disabled
• OOS-MA,MT/Locked-enabled,maintenance
To Next Page
Loading...
