5-14
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 5 Provision Transponder and Muxponder Cards
DLP-G217 Change Line Settings for TXP_MR_10G and TXP_MR_10E Cards
Step 4 Click Apply.
Step 5 Return to your originating procedure (NTP).
DLP-G217 Change Line Settings for TXP_MR_10G and TXP_MR_10E Cards
Step 1 In node view, double-click the TXP_MR_10G or TXP_MR_10E card where you want to change the line
settings.
Step 2 Click the Provisioning > Line > SONET (including 10G Ethernet WAN phy) tabs.
Step 3 Modify any of the settings described in Table 5-4.
Note In Table 5-4, some parameter tabs do not always apply to both the TXP_MR_10G cards and the
TXP_MR_10E cards. If a tab does not apply, it will not appear in CTC.
AIS/Squelch
Configuration
(TXP_MR_10E only) Sets the
transparent termination mode
configuration.
• Squelch
• AIS
• Squelch
• AIS
Wavelength Sets the wavelength of the DWDM
side optical transmitter.
• First Tunable Wavelength
• Further wavelengths in
100-GHz ITU spacing
• Supported wavelengths are in
white and marked by asterisks
(**); unsupported
wavelengths are gray.
Note The four available
wavelengths are listed in
the Card Parameters
section of the window and
also on the Maintenance >
Info tab.
• First Tunable Wavelength
• Further wavelengths in
100-GHz ITU spacing
• Supported wavelengths are in
white and marked by asterisks
(**); unsupported
wavelengths are gray.
Note The four available
wavelengths are listed in
the Card Parameters
section of the window and
also on the Maintenance >
Info tab.
Purpose This task changes the line settings for TXP_MR_10G and TXP_MR_10E
transponder cards.
Tools/Equipment None
Prerequisite Procedures DLP-G46 Log into CTC, page 2-25
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
Table 5-3 TXP_MR-10G and TXP_MR_10E Card Settings
Parameter Description Options – ONS 15454 Options – ONS 15454 SDH
To Next Page
Loading...
