7-21
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 7 Create Channels and Circuits
NTP-G61 Modify and Delete Overhead Circuits
Step 8 Click Finish.
Step 9 Return to your originating procedure (NTP).
NTP-G61 Modify and Delete Overhead Circuits
Caution Deleting circuits can be service affecting and should be performed during a maintenance window.
Step 1 Complete the “DLP-G46 Log into CTC” task on page 2-25 for a node on the network where you want
to repair or delete a circuit. If you are already logged in, continue with Step 2.
Step 2 As needed, complete the “DLP-G111 Repair an IP Tunnel” task on page 7-21.
Step 3 As needed, complete the “DLP-G112 Delete Overhead Circuits” task on page 7-22.
Stop. You have completed this procedure.
DLP-G111 Repair an IP Tunnel
Step 1 Obtain the original IP address of the node in question.
Step 2 From the View menu, choose Go to Network View.
Step 3 From the Tools menu, choose Overhead Circuits > Repair IP Circuits.
Step 4 Review the text in the IP Repair wizard and click Next.
Step 5 In the Node IP address area, complete the following:
• Node—Choose the node that has a PARTIAL circuit.
Purpose This procedure repairs IP circuits and deletes overhead circuits.
Tools/Equipment None
Prerequisite Procedures NTP-G60 Create Overhead Circuits, page 7-13
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
Purpose This task repairs circuits that have a PARTIAL status as a result of node
IP address changes.
Tools/Equipment None
Prerequisite Procedures DLP-G107 Create an IP-Encapsulated Tunnel, page 7-17
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
To Next Page
Loading...
