10-33
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 10 Manage the Node
DLP-G176 Modify a Splitter Protection Group
DLP-G176 Modify a Splitter Protection Group
Step 1 In node view, click the Provisioning > Protection tabs.
Step 2 In the Protection Groups area, click the splitter protection group that you want to modify.
Step 3 Click Edit.
Step 4 In the Selected Group area, you can modify the following, as needed:
• Name—Type the changes to the protection group name. The name can have up to 32 alphanumeric
characters.
• Revertive—Check this box if you want traffic to revert to the working card after failure conditions
stay corrected for the amount of time chosen from the Reversion Time list. Uncheck this box if you
do not want traffic to revert.
• Reversion time—If the Revertive check box is selected, choose the reversion time from the
Reversion time drop-down list. The range is 0.5 to 12.0 minutes. The default is 5.0 minutes. This is
the amount of time that will elapse before the traffic reverts to the working card. Traffic can revert
when conditions causing the switch are cleared.
Step 5 Click OK. Confirm that the changes appear.
Step 6 Return to your originating procedure (NTP).
DLP-G177 Delete a Y-Cable Protection Group
Step 1 In node view, click the Provisioning > Protection tabs.
Step 2 In the Protection Groups area, click the protection group you want to delete.
Step 3 Click Delete.
Purpose This task modifies a splitter protection group for any client port on a
TXPP_MR_2.5G or MXPP_MR_2.5G card. Splitter protection is
automatically created when the TXPP or MXPP card is installed.
Tools/Equipment None
Prerequisite Procedures DLP-G46 Log into CTC, page 2-25
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
Purpose This task deletes a Y-cable protection group.
Tools/Equipment None
Prerequisite Procedures DLP-G46 Log into CTC, page 2-25
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
To Next Page
Loading...
