Cisco ONS 15454 DWDM - DLP- G162 Change IP Settings

10-19
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 10 Manage the Node
DLP-G162 Change IP Settings
• DLP-G266 Modify Backplane Port IP Settings, page 10-21
• DLP-G267 Disable Node Security Mode, page 10-22
• DLP-G163 Modify a Static Route, page 10-23
• DLP-G164 Delete a Static Route, page 10-24
• DLP-G165 Disable OSPF, page 10-24
• DLP-G59 Set Up or Change Open Shortest Path First Protocol, page 3-19
• DLP-G166 Delete a Proxy Tunnel, page 10-25
• DLP-G167 Delete a Firewall Tunnel, page 10-25
Step 4 Complete the “NTP-G103 Back Up the Database” procedure on page 13-2.
Stop. You have completed this procedure.
DLP-G162 Change IP Settings
Caution Changing the node IP address, subnet mask, or IIOP listener port causes the TCC2s/TCC2Ps to reboot.
If Ethernet circuits using Spanning Tree Protocol (STP) originate or terminate on E-Series Ethernet
cards installed in the node, circuit traffic will be lost for several minutes while the spanning trees
reconverge. Other circuits are not affected by TCC2/TCC2P reboots.
Step 1 In node view, click the Provisioning > Network > General tabs.
Step 2 Change any of the following, as required:
• IP Address
• Suppress CTC IP Display
• LCD IP Setting
• Default Router
• Forward DHCP Request To
• Net/Subnet Mask Length
• TCC CORBA (IIOP) Listener Port
• Gateway Settings
Purpose This task changes the IP address, subnet mask, default router, Dynamic
Host Configuration Protocol (DHCP) access, firewall Internet Inter-Object
Request Broker Protocol (IIOP) listener port, LCD IP display, and proxy
server settings.
Tools/Equipment None
Prerequisite Procedures DLP-G46 Log into CTC, page 2-25
DLP-G56 Provision IP Settings, page 3-12
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Superuser