Cisco ONS 15454 DWDM - NTP- G64 View Alarms, History, Events, and Conditions; Table 8-1 Alarm Column Descriptions

8-6
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 8 Manage Alarms
NTP-G64 View Alarms, History, Events, and Conditions
NTP-G64 View Alarms, History, Events, and Conditions
Step 1 Complete the “DLP-G46 Log into CTC” task on page 2-25.
Step 2 Complete the “DLP-G115 View Alarms” task on page 8-6 as needed.
Step 3 Complete the “DLP-G116 View Alarm or Event History” task on page 8-8 as needed.
Step 4 Complete the “DLP-G117 Change the Maximum Number of Session Entries for Alarm History” task on
page 8-9 as needed.
Step 5 Complete the “DLP-G118 Display Alarms and Conditions Using Time Zone” task on page 8-11 as
needed.
Step 6 Complete the “DLP-G119 Synchronize Alarms” task on page 8-11 as needed.
Step 7 Complete the “DLP-G120 View Conditions” task on page 8-12 as needed.
Stop. You have completed this procedure.
DLP-G115 View Alarms
Step 1 In card, node, or network view, click the Alarms tab to view the alarms for that card, node, or network.
Table 8-1 describes the columns in the Alarms window.
Purpose Use this procedure to view current or historical alarms and conditions for
a card, node, or network. This information is useful for monitoring and
troubleshooting hardware and software events.
Tools/Equipment None
Prerequisite Procedures None
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
Purpose Use this task to view current alarms on a card, node, or network.
Tools/Equipment None
Prerequisite Procedures DLP-G46 Log into CTC, page 2-25
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
Table 8-1 Alarm Column Descriptions
Column Information Recorded
Num Sequence number of the original alarm.
Ref Reference number of the original alarm.