Cisco ONS 15454 DWDM - NTP- G108 Viewing the Audit Trail Records

13-14
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 13 Maintain the Node
NTP-G108 Viewing the Audit Trail Records
Step 2 Right-click the card that you want to reset to reveal a shortcut menu.
Step 3 Click Reset Card.
Step 4 Click Yes when the confirmation dialog box appears.
The card LED on the ONS 15454 shelf graphic will go through the following sequence: Fail (white
LED), Ldg (white LED), and Act (green LED). The reset should complete within 1 to 2 minutes.
Step 5 If you performed a Y-cable protection group switch in Step 1, complete the “DLP-G180 Clear a Manual
or Force Y-Cable or Splitter Protection Switch” task on page 10-36. If not, continue with Step 6.
Step 6 Return to your originating procedure (NTP).
NTP-G108 Viewing the Audit Trail Records
Step 1 Complete the “DLP-G46 Log into CTC” task on page 2-25 at the node where you want to view the audit
trail log. If you are already logged in, continue with Step 2.
Step 2 In node view, click the Maintenance > Audit tabs.
Step 3 Click Retrieve.
A window containing the most recent audit trail records appears as shown in Figure 13-3.
Purpose This procedure explains how to view audit trail records. Audit trail records
are useful for maintaining security, recovering lost transactions, and
enforcing accountability. Accountability refers to tracing user activities;
that is, associating a process or action with a specific user.
Tools/Equipment None
Prerequisite
Procedures
None
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher