10-6
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 10 Manage the Node
NTP-G80 Change Node Management Information
Note The 32WSS is designed to handle minor differences in output power. The output power does
not need to be exactly the same for all wavelengths.
Figure 10-1 shows an example of ROADM node with equalized output power.
Figure 10-1 Equalized ROADM Power Example
Step 4
If needed, click Refresh to update the display.
Stop. You have completed this procedure.
NTP-G80 Change Node Management Information
Step 1 Complete the “DLP-G46 Log into CTC” task on page 2-25. If you are already logged in, continue with
Step 2.
Step 2 Complete the “NTP-G103 Back Up the Database” procedure on page 13-2.
Step 3 In node view, click the Provisioning > General tabs.
Step 4 Complete the “DLP-G160 Change the Node Name, Date, Time, and Contact Information” task on
page 10-7, as needed.
Step 5 Complete the “DLP-G161 Change the Login Legal Disclaimer” task on page 10-8, as needed.
Step 6 After confirming the changes, complete the “NTP-G103 Back Up the Database” procedure on page 13-2.
Stop. You have completed this procedure.
Purpose This procedure changes the node name, date, time, contact information,
and login legal disclaimer.
Tools/Equipment None
Prerequisite Procedures NTP-G24 Set Up Name, Date, Time, and Contact Information, page 3-8
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
To Next Page
Loading...
