Cisco ONS 15454 DWDM - LAN Connections

15-47
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 15 Shelf Hardware Reference
15.14.3 LAN Connections
15.14.3 LAN Connections
Use the LAN pins on the ONS 15454 ANSI backplane to connect the ONS 15454 ANSI to a workstation
or Ethernet LAN, or to a LAN modem for remote access to the node. You can also use the LAN port on
the TCC/TCC2P faceplate to connect a workstation or to connect the ONS 15454 ANSI to the network.
Table 15-14 shows the LAN pin assignments.
Before you can connect an ONS 15454 ANSI to other ONS 15454 ANSI shelves or to a LAN, you must
change the default IP address that is shipped with each ONS 15454 ANSI (192.1.0.2).
15.14.4 TL1 Craft Interface Installation
You can use the craft pins on the ONS 15454 ANSI backplane or the EIA/TIA-232 port on the
TCC2/TCC2P faceplate to create a VT100 emulation window to serve as a TL1 craft interface to the
ONS 15454 ANSI. Use a straight-through cable to connect to the EIA/TIA-232 port. Table 15-15 shows
the pin assignments for the CRAFT pin field.
Note You cannot use the craft backplane pins and the EIA/TIA-232 port on the TCC2/TCC2P card
simultaneously.
Table 15-14 LAN Pin Assignments
Pin Field Backplane Pins RJ-45 Pins
LAN 1
Connecting to data circuit-terminating
equipment (DCE
1
, a hub or switch)
1. The Cisco ONS 15454 ANSI is DCE.
B2 1
A2 2
B1 3
A1 6
LAN 1
Connecting to data terminal equipment
(DTE) (a PC/workstation or router)
B1 1
A1 2
B2 3
A2 6
Table 15-15 Craft Interface Pin Assignments
Pin Field Contact Function
Craft A1 Receive
A2 Transmit
A3 Ground
A4 DTR