3-25
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 3 Turn Up a Node
DLP-G62 Provision the IIOP Listener Port on the CTC Computer
DLP-G62 Provision the IIOP Listener Port on the CTC Computer
Step 1 From the Edit menu, choose Preferences.
Step 2 In the Preferences dialog box, click the Firewall tab.
Step 3 In the CTC CORBA (IIOP) Listener Port area, choose a listener port option:
• Default - Variable—Use to connect to ONS 15454 nodes from within a firewall or if no firewall is
used (default).
• Standard Constant—Use Port 683, the CORBA default port number.
• Other Constant—If Port 683 is not used, enter the IIOP port defined by your administrator.
Step 4 Click Apply. A warning appears telling you that the port change will apply during the next CTC login.
Step 5 Click OK.
Step 6 In the Preferences dialog box, click OK.
Step 7 To access the ONS 15454 using the IIOP port, log out of CTC then log back in. (To log out, choose Exit
from the File menu).
Step 8 Return to your originating procedure (NTP).
NTP-G132 Provision OSI
Purpose This task selects the IIOP listener port on CTC and must be completed if
the computer running CTC resides behind a firewall.
Tools/Equipment IIOP listener port number from LAN or firewall administrator.
Prerequisite Procedures NTP-G22 Verify Common Card Installation, page 3-4
DLP-G46 Log into CTC, page 2-25
Required/As Needed As needed.
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
Purpose This procedure provisions the ONS 15454 so it can be networked with
other vendor NEs that use the OSI protocol stack for data communications
network (DCN) communications. This procedure provisions the TID
Address Resolution Protocol (TARP), OSI routers, manual area addresses,
subnetwork points of attachment, and IP-over-OSI tunnels.
Tools/Equipment None
Prerequisite Procedures NTP-G15 Install the Common Control Cards, page 1-71
Required/As Needed As needed
Onsite/Remote Onsite
Security Level Provisioning or higher
To Next Page
Loading...
