Cisco ONS 15454 DWDM - DLP- G249 Use the Reinitialization Tool to Clear the Database and Upload Software (UNIX)

13-7
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 13 Maintain the Node
DLP-G249 Use the Reinitialization Tool to Clear the Database and Upload Software (UNIX)
• Search Path—Enter the path to the CISCO15454 folder on the CD drive.
Step 6 Click Go.
Caution Before continuing with the next step, verify that the database to upload is correct. You cannot reverse
the upload process after you click Yes.
Step 7 Review the information in the Confirm NE Re-Initialization dialog box, then click Yes to start the
reinitialization.
The reinitialization begins. After the software is downloaded and activated, and the database is uploaded
to the TCC2/TCC2P cards, “Complete” appears in the status bar and the TCC2/TCC2P cards will reboot.
Wait a few minutes for the reboot to complete.
Step 8 After the reboot is complete, log into the node using the “DLP-G46 Log into CTC” task on page 2-25.
Step 9 Complete the “NTP-G24 Set Up Name, Date, Time, and Contact Information” procedure on page 3-8
and the “NTP-G26 Set Up CTC Network Access” procedure on page 3-11.
Step 10 Return to your originating procedure (NTP).
DLP-G249 Use the Reinitialization Tool to Clear the Database and Upload
Software (UNIX)
Caution Restoring a node to the factory configuration deletes all cross-connects on the node.
Purpose This task reinitializes the ONS 15454 using the CTC reinitialization tool
on a UNIX computer. Reinitialization uploads a new software package
to the TCC2/TCC2P cards, clears the node database, and restores the
factory default parameters.
Tools/Equipment ONS 15454 SONET System Software CD, Version 5.0.x
JRE 1.4.2 must be installed on the computer to log into the node at the
completion of the reinitialization. The reinitialization tool can run on
JRE 1.3.1_02 or JRE 1.4.2.
Prerequisite Procedures NTP-G103 Back Up the Database, page 13-2
NTP-G17 Set Up Computer for CTC, page 2-2
One of the following:
• NTP-G18 Set Up CTC Computer for Local Craft Connection to the
ONS 15454, page 2-9, or
• NTP-G19 Set Up a CTC Computer for a Corporate LAN
Connection to the ONS 15454, page 2-21
Required/As Needed As needed to clear the existing database from a TCC2/TCC2P and
restore the node default settings.
Onsite/Remote Onsite
Security Level Superuser