Cisco ONS 15454 DWDM - DLP- G57 Set the IP Address, Default Router, and Network Mask Using the LCD; Figure 3-2 Selecting the IP Address Option; Figure 3-3 Changing the IP Address

3-15
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 3 Turn Up a Node
DLP-G57 Set the IP Address, Default Router, and Network Mask Using the LCD
DLP-G57 Set the IP Address, Default Router, and Network Mask Using the LCD
Note You cannot perform this task if the LCD IP Display field on the node view Provisioning > Network tab
is set to Display Only or Suppress Display. See the “DLP-G56 Provision IP Settings” task on page 3-12
to view or change the LCD IP Display field.
Note The LCD reverts to normal display mode after 5 seconds of button inactivity.
Step 1 On the ONS 15454 front panel, repeatedly press the Slot button until Node appears on the LCD.
Step 2 Repeatedly press the Port button until the following displays:
• To change the node IP address, Status=IpAddress (Figure 3-2)
• To change the node network mask, Status=Net Mask
• To change the default router IP address, Status=Default Rtr
Figure 3-2 Selecting the IP Address Option
Step 3
Press the Status button to display the node IP address (Figure 3-3), the node subnet mask length, or the
default router IP address.
Figure 3-3 Changing the IP Address
Step 4
Push the Slot button to move to the digit of the IP address or subnet mask that you want to change. The
selected digit flashes.
Purpose This task changes the ONS 15454 IP address, default router, and network
mask using the LCD on the fan-tray assembly. Use this task if you cannot
log into CTC.
Tools/Equipment None
Prerequisite Procedures DLP-G33 Install the TCC2 or TCC2P Card, page 1-72
Required/As Needed As needed
Onsite/Remote Onsite
Security Level None
FAN FAIL
Slot
Slot-0
Status=IpAddress
44089
CRIT MAJ MIN
Status Port
FAN FAIL
Slot
172.020.214.107
<Next Done Mod>
44090
CRIT MAJ MIN
Status Port