5-47
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 5 Provision Transponder and Muxponder Cards
DLP-G228 Change Line OTN Settings for MXP_2.5G_10G and MXP_2.5G_10E Cards
Step 4 Click Apply.
Step 5 Return to your originating procedure (NTP).
Transmit Displays the current transmit string; sets
a new transmit string. You can click the
button on the right to change the display.
Its title changes, based on the current
display mode. Click Hex to change the
display to hexadecimal (button changes to
ASCII); click ASCII to change the
display to ASCII (button changes to Hex).
String of trace string size;
trail trace identifier is 64 bytes in length.
Expected Displays the current expected string; sets
a new expected string. You can click the
button on the right to change the display.
Its title changes, based on the current
display mode. Click Hex to change the
display to hexadecimal (button changes to
ASCII); click ASCII to change the
display to ASCII (button changes to Hex).
String of trace string size
Received (Display only) Displays the current
received string. You can click Refresh to
manually refresh this display, or check
the Auto-refresh every 5 sec box to keep
this field updated.
String of trace string size
Table 5-28 MXP_2.5G_10G and MXP_2.5G_10E Muxponder Card Trail Trace Identifier
Settings (continued)
Parameter Description Options
To Next Page
Loading...
