Cisco ONS 15454 DWDM - Page 375

5-37
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 5 Provision Transponder and Muxponder Cards
DLP-G224 Change Section Trace Settings for MXP_2.5G_10G and MXP_2.5G_10E Cards
Step 7 Click the Provisioning > Line > Section Trace tabs.
Step 8 Modify any of the settings described in Table 5-18.
Step 9 Click Apply.
Step 10 Return to your originating procedure (NTP).
Table 5-18 TXP_MR_10G and MXP_MR_10E Card Section Trace Settings
Parameter Description Options
Port Sets the port number.
• 1
• 2
• 3
• 4
Trace Mode Sets the trace mode.
• Off/None
• Manual
Section Trace
String Size
Sets the trace string size. Select either
radio button.
• 1 byte
• 16 byte
Transmit Displays the current transmit string; sets
a new transmit string. You can click the
button on the right to change the display.
Its title changes, based on the current
display mode. Click Hex to change the
display to hexadecimal (button changes to
ASCII); click ASCII to change the
display to ASCII (button changes to Hex).
String of trace string size
Expected Displays the current expected string; sets
a new expected string. You can click the
button on the right to change the display.
Its title changes, based on the current
display mode. Click Hex to change the
display to hexadecimal (button changes to
ASCII); click ASCII to change the
display to ASCII (button changes to Hex).
String of trace string size
Received (Display only) Displays the current
received string. You can click Refresh to
manually refresh this display, or check
the Auto-refresh every 5 sec check box to
keep this field updated.
String of trace string size