Cisco ONS 15454 DWDM - Page 1077

B-47
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
December 2006
Appendix B Hardware Specifications
B.5.6 TXP_MR_10E Card Specifications
– 1558.17 to 1561.01 nm (four channels)
L-band frequency plan (five card versions, each with eight tunable channels on the ITU 50-GHz
grid):
– 1577.44 to 1580.35 nm (eight channels)
– 1580.77 to 1583.69 nm (eight channels)
– 1584.11 to 1587.04 nm (eight channels)
– 1587.46 to 1590.41 nm (eight channels)
– 1590.83 to 1593.79 nm (eight channels)
• Receiver (trunk side)
– Receiver: APD
– Link loss budget: 24 dB minimum, with no dispersion or 22 dB optical path loss at
BER = 1 * 10 exp – 12 including dispersion
– Receiver input wavelength range: 1290 to 1605 nm
• Line (client side):
– 10-Gigabit Small Form-factor Pluggable (XFP)-based SR
– Bit rate: 10GE (10.3125 Gbps), 10G FC (10.51875 Gbps), or STM-64/OC-192
– Code: Scrambled NRZ
– Fiber: 1310-nm single-mode
– Maximum chromatic dispersion allowance: 6.6 ps/nm
– Loopback modes: Terminal and facility
– Connectors: LC
– Compliance: Telcordia GR-253-CORE, ITU-T G.707, ITU-T G.957, ITU-T G.691
• Transmitter (client side)
– Maximum transmitter output power: –1 dBm
– Minimum transmitter output power: –6 dBm
– Center wavelength: 1290 to 1330 nm
Table B-22 TXP_MR_10E Receiver Trunk Side Specifications
OSNR
1
FEC Type Pre-FEC BER Post-FEC BER
Input Power
Sensitivity
2
Chromatic Dispersion
Tolerance
30 dB Off <10 exp – 12 N/A – 8 to – 20 dBm +/– 1200 ps/nm
26 dB Off <10 exp – 12 N/A – 8 to – 20 dBm + – 1000 ps/nm
26 dB Off <10 exp – 12 N/A – 8 to – 22 dBm —
17 dB Standard <10 exp – 5 <10 exp – 15 – 8 to – 18 dBm +/– 800 ps/nm
15 dB Standard <10 exp – 5 <10 exp – 15 – 8 to – 18 dBm —
15 dB Enhanced <7 x 10 exp – 4 <10 exp – 15 – 8 to – 18 dBm +/– 800 ps/nm
14 dB Enhanced <7 x 10 exp – 4 <10 exp – 15 – 8 to – 18 dBm —
1. Optical Signal-to-Noise ratio (OSNR) defined with 0.1 nm Resolution Bandwidth (RBW)
2. Receiver filter bandwidth greater than or equal to 180 pm (at – 3 dBm)