11-4
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 11 Change DWDM Card Settings
DLP-G199 Change the OSCM and OSC-CSM Optical Service Channel Settings
Admin State Sets the port service state unless network
conditions prevent the change. For more
information about administrative states, see
Appendix C, “DWDM Administrative and
Service States.”
• IS (ANSI) or Unlocked (ETSI)—Puts the port in
service. The port service state changes to IS-NR (ANSI)
or Unlocked-enabled (ETSI).
• IS,AINS (ANSI) or
Unlocked,automaticInService (ETSI)—Puts the port in
automatic in-service. The port service state changes to
OOS-AU,AINS (ANSI) or
Unlocked-disabled,automaticInService (ETSI).
• OOS,DSBLD (ANSI) or Locked,disabled
(ETSI)—Removes the port from service and disables it.
The port service state changes to OOS-MA,DSBLD
(ANSI) or Locked-enabled,disabled (ETSI).
• OOS,MT (ANSI) or Locked,maintenance
(ETSI)—Removes the port from service for
maintenance. The port service state changes to
OOS-MA,MT (ANSI) or Locked-enabled,maintenance
(ETSI).
Service State Identifies the autonomously generated state
that gives the overall condition of the port.
Service states appear in the format: Primary
State-Primary State Qualifier, Secondary
State. For more information about service
states, see Appendix C, “DWDM
Administrative and Service States.”
• IS-NR (In-Service and Normal [ANSI]) or
Unlocked-enabled (ETSI)—The port is fully
operational and is performing as provisioned.
• OOS-AU,AINS (Out-Of-Service and Autonomous,
Automatic In-Service [ANSI]) or
Unlocked-disabled,automaticInService (ETSI)—The
port is out of service, but traffic is carried. Alarm
reporting is suppressed. The ONS node monitors the
ports for an error-free signal. After an error-free signal
is detected, the port stays in the
OOS-AU,AINS/Unlocked-disabled,automaticInService
state for the duration of the soak period. After the soak
period ends, the port service state changes to
IS-NR/Unlocked-enabled.
• OOS-MA,DSBLD (Out-of-Service and Management,
Disabled [ANSI]) or Locked-enabled,disabled
(ETSI)—The port is out of service and unable to carry
traffic.
• OOS-MA,MT (Out-of-Service and Management,
Maintenance [ANSI]) or Locked-enabled,maintenance
(ETSI)—The port is out of service for maintenance.
Alarm reporting is suppressed, but traffic is carried and
loopbacks are allowed.
Table 11-1 OSCM and OSC-CSM Card OC-3 Settings (continued)
Parameter Description Options
To Next Page
Loading...
