11-10
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 11 Change DWDM Card Settings
DLP-G203 Change the OSCM and OSC-CSM ALS Maintenance Settings
Step 6 Click Apply. If the change affects traffic, a warning message displays. Click Yes to complete the
change.
Step 7 Return to your originating procedure (NTP).
DLP-G203 Change the OSCM and OSC-CSM ALS Maintenance Settings
Step 1 In node view, double-click the OSC-CSM or OSCM card where you want to change the ALS
maintenance settings.
Step 2 Click the Maintenance > ALS tabs.
Step 3 Modify any of the settings described in Table 11-6. The provisionable parameters are listed in the
options column in the table.
VOA Degrade
High (dBm)
Does not apply to OSCM and OSC-CSM
cards.
—
VOA Degrade
Low (dBm)
Does not apply to OSCM and OSC-CSM
cards.
—
Purpose This task changes the automatic laser shutdown (ALS) maintenance
settings for the OSC-CSM and OSCM cards.
Tools/Equipment None
Prerequisite Procedures DLP-G46 Log into CTC, page 2-25
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
Table 11-5 OSCM and OSC-CSM Cards Optical Channel Alarm Thresholds Settings (continued)
Parameter Description Options
To Next Page
Loading...
