Siemens RUGGEDCOM ROX II User Manual

Chapter 4
Device Management
RUGGEDCOM ROX II
CLI User Guide
56 Viewing Chassis Information and Status
model RX5000
software license "Layer 3 Standard Edition"
order code RX5000-L3-MNT-HI-L3SE-CG01-XX-S01-E02-XX-XX
rox release "ROX 2.6.0-QA3.14 (2014-08-11 18:00)"
system serial number RX5000R-0812-00664
This table or list provides the following information:
Parameter Description
model Synopsis:  A string
The RuggedCom device model name.
software-license Synopsis:  A string
The current software capability.
rox-release Synopsis:  A string
The release of ROX running on the chassis.
This parameter is mandatory.
system-serial-number Synopsis:  A string 1 to 32 characters long
The system serial number on the chassis label.
This parameter is mandatory.
last-integrity-check Synopsis:  A string 1 to 32 characters long
The last time the firmware integrity was checked.
last-integrity-check-result Synopsis:  A string
The result of the last integrity check.
Section4.2
Viewing Chassis Information and Status
This section describes how to view information about the device chassis, such as its configuration and operating
status.
CONTENTS
• Section4.2.1, “Viewing the Slot Hardware”
• Section4.2.2, “Viewing Module Information”
• Section4.2.3, “Viewing Flash Card Storage Utilization”
• Section4.2.4, “Viewing CPU/RAM Utilization”
• Section4.2.5, “Viewing the Slot Status”
• Section4.2.6, “Viewing the Slot Sensor Status”
• Section4.2.7, “Viewing the Power Controller Status”
Section4.2.1
Viewing the Slot Hardware
To view a list of the hardware installed in each slot, type:

Siemens RUGGEDCOM ROX II Specifications

General

Brand	Siemens
Model	RUGGEDCOM ROX II
Category	Network Hardware
Language	English