Siemens RUGGEDCOM ROX II User Manual

Chapter 13
Unicast and Multicast Routing
RUGGEDCOM ROX II
CLI User Guide
544 Enabling/Disabling MPLS
Parameter Description
outgoing-interface Synopsis:  A string
The outgoing interface.
next-hop Synopsis:  A string
The destination next hop router.
uptime Synopsis:  A string
The time this entry has been up.
Section13.10.3
Enabling/Disabling MPLS
To enable MPLS routing, do the following:
1. Make sure the CLI is in Configuration mode.
2. Enable or disable MPLS by typing the following commands:
Enable
mpls enable
Disable
no mpls enable
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section13.10.4
Managing the MPLS Interfaces
This section describes how to manage the MPLS interfaces.
CONTENTS
• Section13.10.4.1, “Viewing the Status of MPLS Interfaces”
• Section13.10.4.2, “Viewing a List of MPLS Interfaces”
• Section13.10.4.3, “Enabling/Disabling an MPLS Interface”
Section13.10.4.1
Viewing the Status of MPLS Interfaces
To view the status of the MPLS interfaces on the device, type:
show mpls status interfaces
If MPLS interfaces have been enabled on the device, a table similar to the following example appears:
show mpls status interfaces
MPLS
INTERFACES STATUS

Siemens RUGGEDCOM ROX II Specifications

General

Brand	Siemens
Model	RUGGEDCOM ROX II
Category	Network Hardware
Language	English