Siemens RUGGEDCOM ROX II User Manual

Chapter 13
Unicast and Multicast Routing
RUGGEDCOM ROX II
CLI User Guide
598 Managing Multicast Group Prefixes
2. Delete the chosen RP address by typing:
no routing multicast dynamic pim-sm rp-address static-address
Where static-address is the Static RP (Rendezvous Point) address
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section13.14.9
Managing Multicast Group Prefixes
When nominated to a Rendezvous Point (RP), the device can serve up to 20 groups of multicast devices. The
device is associated with a multicast group by defining the prefix for the group's multicast IP address (e.g.
225.1.2.0/24).
CONTENTS
• Section13.14.9.1, “Viewing a List of Multicast Group Prefixes”
• Section13.14.9.2, “Adding a Multicast Group Prefix”
• Section13.14.9.3, “Deleting a Multicast Group Prefix”
Section13.14.9.1
Viewing a List of Multicast Group Prefixes
To view a list of multicast group prefixes, type:
show running-config routing multicast dynamic pim-sm group-prefix
If prefixes have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config routing multicast dynamic pim-sm group-prefix
routing multicast dynamic pim-sm
group-prefix 225.1.2.0/24
!
!
If no prefixes have been configured, add prefixes as needed. For more information, refer to Section13.14.9.2,
“Adding a Multicast Group Prefix”.
Section13.14.9.2
Adding a Multicast Group Prefix
To add a multicast group prefix, do the following:
NOTE
A maximum of 20 group prefixes can be defined for PIM-SM.
1. Make sure the CLI is in Configuration mode.
2. Add the multicast group prefix by typing:
routing multicast dynamic pim-sm group-prefix prefix

Siemens RUGGEDCOM ROX II Specifications

General

Brand	Siemens
Model	RUGGEDCOM ROX II
Category	Network Hardware
Language	English