To Next Page

To Previous Page

Chapter 13

Unicast and Multicast Routing

RUGGEDCOM ROX II

CLI User Guide

478 Managing Routing Interfaces

no routing rip redistribute [ bgp | ospf | connected | static | kernel ]

3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.

Section13.7.11

Managing Routing Interfaces

This section describes how to manage interfaces for RIP routes.

CONTENTS

• Section13.7.11.1, “Viewing a List of Routing Interfaces”

• Section13.7.11.2, “Configuring a Routing Interface”

Section13.7.11.1

Viewing a List of Routing Interfaces

To view a list of routing interfaces for a RIP network, type:

show running-config routing rip interface

A table or list similar to the following example appears:

ruggedcom# show running-config routing rip interface | tab

KEY RECEIVE SEND SPLIT

IFNAME MODE CHAIN STRING PASSIVE VERSION VERSION HORIZON

----------------------------------------------------------------------

dummy0 - - - - - - yes

fe-cm-1 - - - - - - yes

switch.0001 - - - - - - yes

Section13.7.11.2

Configuring a Routing Interface

To configure a routing interface for a RIP network, do the following:

NOTE

OSPF regards router interfaces as either passive or active, sending OSPF messages on active interfaces

and ignoring passive interfaces.

1. Make sure the CLI is in Configuration mode.

2. Navigate to routing» rip» interface» {name}, where {name} is the name of the interface.

3. Configure the authentication settings by typing the following commands:

Parameter Description

mode { mode } Synopsis:  { md5-rfc, md5-old-ripd, text, none }

The authentication mode.

key-chain { key-chain } Synopsis:  A string

Siemens RUGGEDCOM ROX II User Manual

Questions and Answers: