Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
Chapter 13
Unicast and Multicast Routing
Deleting a Redistribution Metric 537
Where:
• vrf is the name of the chosen VRF
3. Configure the following parameter(s) as required:
Parameter Description
metric-type { metric-type } Synopsis:  An 8-bit signed integer between 1 and 2
Default:  2
The OSPF exterior metric type for redistributed routes.
metric { metric } Synopsis:  A 32-bit unsigned integer between 0 and 16777214
The metric for redistributed routes.
route-map { route-map } Synopsis:  A string
The route map name.
4. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section13.9.8.3
Deleting a Redistribution Metric
To delete a redistribution metric for dynamic OSPF routes, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the metric by typing:
• For Standard OSPF Routes
no routing ospf redistribute [ bgp | rip | connected | static | kernel ]
• For VRF Routes via OSPF
no routing ospf vrf vrf redistribute [ bgp | rip | connected | static | kernel ]
Where:
• vrf is the name of the chosen VRF
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section13.9.9
Managing Routing Interfaces
This section describes how to manage interfaces for OSPF routes.
CONTENTS
• Section13.9.9.1, “Viewing a List of Routing Interfaces”
• Section13.9.9.2, “Configuring a Routing Interface”

Siemens RUGGEDCOM ROX II Specifications

General

Brand	Siemens
Model	RUGGEDCOM ROX II
Category	Network Hardware
Language	English