RUGGEDCOM ROX II
CLI User Guide
Chapter 6
Security
Associating an Interface with a Zone 195
7. Configure a broadcast address for the interface. For more information configuring a broadcast address, refer
to Section6.9.10.4, “Configuring a Broadcast Address”.
8. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section6.9.10.3
Associating an Interface with a Zone
To associate an interface with a pre-defined zone or mark the associated zone as undefined, do the following:
1. Make sure the CLI is in Configuration mode.
2. Navigate to security» firewall» fwconfig» {firewall}» fwinterface{interface}» zone, where {firewall} is
the name of the firewall and {interface} is the name of the interface.
3. Configure the following parameter(s) as required:
Parameter Description
predefined-zone { predefined-zone } Synopsis: A string
A pre-defined zone
undefined-zone This is used in conjunction with hosts definitions.
4. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section6.9.10.4
Configuring a Broadcast Address
To configure a broadcast address for an interface, do the following:
1. Make sure the CLI is in Configuration mode.
2. Navigate to security» firewall» fwconfig» {firewall}» fwinterface{interface}» broadcast-addr, where
{firewall} is the name of the firewall and {interface} is the name of the interface.
3. Configure the following parameter(s) as required:
Parameter Description
ipv4-address { ipv4-address } Synopsis: A string
An IPv4 address for a broadcast address.
detect Automatic detection of the broadcast address(es).
none The default.
4. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section6.9.10.5
Deleting an Interface
To delete an interface, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the interface by typing:
To Next Page
Loading...
Need help?
General
