Siemens RUGGEDCOM ROX II User Manual

Chapter 13
Unicast and Multicast Routing
RUGGEDCOM ROX II
CLI User Guide
436 Viewing the Status of IPv6 Routes
192.168.0.0/24 switch.0001 kernel
This table/list provides the following information:
Parameter Description
destination Synopsis:  A string
The network/prefix.
gateway Synopsis:  A string
The gateway address.
interface Synopsis:  A string
The interface name.
type Synopsis:  A string
The route type.
weight Synopsis:  A string
The route weight.
metric Synopsis:  A string
The route metric value.
If no IPv4 routes have been configured, add routes as needed. For more information, refer to Section7.1.3.2,
“Adding an IPv4 Address”.
Section13.2
Viewing the Status of IPv6 Routes
To view the status of the IPv6 routes configured on the device, type:
show routing status ipv6routes
If IPv6 routes have been configured, a table or list similar to the following example appears:
ruggedcom# show routing status ipv6routes
DESTINATION GATEWAY INTERFACE TYPE WEIGHT METRIC
-----------------------------------------------------------
fe80:/64 switch kernel 256
fe80:/64 dp1 kernel 256
fe80:/64 vrf_lo kernel 256
fe80:/64 switch.0001 kernel 256
fe80:/64 fe-cm-1 kernel 256
fe80:/64 switch.4094 kernel 256
ff00:/8 switch 256
ff00:/8 dp1 256
ff00:/8 vrf_lo 256
ff00:/8 switch.0001 256
ff00:/8 fe-cm-1 256
ff00:/8 switch.4094 256
This table/list provides the following information:
Parameter Description
destination Synopsis:  A string
The network/prefix.
gateway Synopsis:  A string

Siemens RUGGEDCOM ROX II Specifications

General

Brand	Siemens
Model	RUGGEDCOM ROX II
Category	Network Hardware
Language	English