Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
Chapter 13
Unicast and Multicast Routing
Adding an Aggregate Address Option 501
Section13.8.9.2
Adding an Aggregate Address Option
To add an option for an aggregate address, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the path by typing:
routing bgp aggregate-address address options [ summary-only | as-set ]
Where:
• address is the subnet address and prefix for the aggregate address
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section13.8.9.3
Deleting an Aggregate Address Option
To delete an option for an aggregate address, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the option by typing:
no routing bgp aggregate-address address options [ summary-only | as-set ]
Where:
• address is the subnet address and prefix for the aggregate address
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section13.8.10
Managing Redistribution Metrics
Redistribution metrics redistribute routing information from other routing protocols, static routes or routes
handled by the kernel. Routes for subnets that are directly connected to the router, but not part of the BGP
network, can also be advertised.
CONTENTS
• Section13.8.10.1, “Viewing a List of Redistribution Metrics”
• Section13.8.10.2, “Adding a Redistribution Metric”
• Section13.8.10.3, “Deleting a Redistribution Metric”
Section13.8.10.1
Viewing a List of Redistribution Metrics
To view a list of redistribution metrics for dynamic BGP routes, type:
show running-config routing bgp redistribute
If metrics have been configured, a table or list similar to the following example appears:

Siemens RUGGEDCOM ROX II Specifications

General

Brand	Siemens
Model	RUGGEDCOM ROX II
Category	Network Hardware
Language	English