Siemens RUGGEDCOM ROX II

Chapter 8
Layer 2
RUGGEDCOM ROX II
CLI User Guide
274 Viewing RMON Port Statistics
Parameter Description
This parameter is mandatory.
speed Synopsis:  { auto, 1.5M, 2.4M, 10M, 100M, 1G, 10G, 1.776M, 3.072M, 7.2M, 1.2K, 2.4K,
9.6K, 19.2K, 38.4K, 57.6K, 115.2K, 230.4K, 4.8K, 76.8K }
Speed (in Megabits-per-second or Gigabits-per-second)
This parameter is mandatory.
duplex Synopsis:  { auto, half, full }
Duplex Setting: { Auto, Half, Full }
This parameter is mandatory.
mtu Synopsis:  A 32-bit signed integer
The Maximum Transmission Unit of frame (in bytes) permitted on the interface.
This parameter is mandatory.
mac Synopsis:  A string 17 characters long
The MAC Address of this specific port.
This parameter is mandatory.
Section8.1.5
Viewing RMON Port Statistics
To view Remote Network Monitoring (RMON) statistics collected for a specific switched Ethernet port, type:
show interfaces switch slot port rmon-stats
Where:
• slot is the name of the module location
• port is the port number (or a list of ports, if aggregated in a port trunk) for the module
A table or list similar to the following example appears:
ruggedcom# show interfaces switch lm1 1 rmon-stats | tab
rmon-stats
in octets 10107903
in pkts 53903
in bcast pkts 607
in mcast pkts 42103
total in octets 10107903
total in pkts 53903
out octets 4974162
out pkts 14356
drop events 0
out bcast pkts 0
out mcast pkts 405
crc align errors 0
undersize pkts 0
oversize pkts 0
fragments 0
jabbers 0
collisions 0
late collisions 0
pkts 64 octets 10978
pkts 65to127 octets 24792
pkts 128to255 octets 19970
pkts 256to511 octets 2469
pkts 512to1023 octets 8410