Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
Chapter 13
Unicast and Multicast Routing
Viewing a List of MPLS Interfaces 545
---------------------
switch.0010 yes
switch.0020 yes
This table provides the following information:
Parameter Description
mpls-interfaces Synopsis:  A string
The interface that has been enabled for MPLS.
status Synopsis:  A string
The operational status.
If no MPLS interface has been enabled, enable interfaces as needed. For more information about enabling MPLS
interfaces, refer to Section13.10.4.3, “Enabling/Disabling an MPLS Interface”.
Section13.10.4.2
Viewing a List of MPLS Interfaces
To view a list of MPLS interfaces, type:
show running-config mpls interface-mpls
If interfaces have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config mpls interface-mpls | tab
IFNAME ENABLED
----------------------
fe-cm-1 false
switch.0001 false
switch.0010 true
switch.0020 false
!
Where:
• IFNAME is the name of the interface
• ENABLED refers to the status of the MPLS operation on the interface
If no MPLS interfaces have been configured, enable interfaces as needed. For more information about enabling
MPLS interfaces, refer to Section13.10.4.3, “Enabling/Disabling an MPLS Interface”.
Section13.10.4.3
Enabling/Disabling an MPLS Interface
To enable or disable an MPLS interface, do the following:
1. Make sure the CLI is in Configuration mode.
2. Enable or disable MPLS interfaces by typing the following commands:
Enable
mpls interface-mpls interface enable

Siemens RUGGEDCOM ROX II Specifications

General

Brand	Siemens
Model	RUGGEDCOM ROX II
Category	Network Hardware
Language	English