RUGGEDCOM ROX II
CLI User Guide
Chapter 7
IP Address Assignment
Deleting an IP Range (IPv4) 251
• For a DHCP subnet
services dhcpserver subnet-name name options iprange start end end
• For an address pool
services dhcpserver subnet-name name options ippool description iprange start end end
Where:
• name is the name of the subnet
• description (if applicable) is the name of the address pool
• start is the starting IP address pool the server uses to offer to the client
• end is the ending IP address pool the server uses to offer to the client
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section7.3.13.3
Deleting an IP Range (IPv4)
To delete an IP range from a DHCP subnet or one of its associated address pools, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the IP range by typing:
• For a DHCP subnet
no dhcpserver subnet-name name options iprange start end end
• For an address pool
no services dhcpserver subnet-name name options ippool description iprange start end end
Where:
• name is the name of the subnet
• description (if applicable) is the name of the address pool
• start is the starting IP address pool the server uses to offer to the client
• end is the ending IP address pool the server uses to offer to the client
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section7.3.14
Managing IP Ranges (IPv6)
An IP range represents the range of IP addresses the DHCP server can assign to clients. IP addresses outside the set
range are reserved for statically addressed clients.
An IP range can be configured for a DHCP subnet and/or its associated address pool(s).
CONTENTS
• Section7.3.14.1, “Viewing a List of IP Ranges (IPv6)”
• Section7.3.14.2, “Adding an IP Range (IPv6)”
• Section7.3.14.3, “Deleting an IP Range (IPv6)”
To Next Page
Loading...
Need help?
General
