Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
Chapter 6
Security
Managing Interfaces 193
Section6.9.10
Managing Interfaces
Firewall interfaces are the LAN and WAN interfaces available to the router. Each interface must be placed in
a network zone. If an interface supports more than one zone, its zone must be marked as undefined and the
interface must use the zone host's setup to define a zone for each subnet on the interface.
Table:Example
Interface Zone
Switch.0001 Loc
Switch.0002 Loc
Switch.0003 Any
Switch.0004 DMZ
W1ppp net
CONTENTS
• Section6.9.10.1, “Viewing a List of Interfaces”
• Section6.9.10.2, “Adding an Interface”
• Section6.9.10.3, “Associating an Interface with a Zone”
• Section6.9.10.4, “Configuring a Broadcast Address”
• Section6.9.10.5, “Deleting an Interface”
Section6.9.10.1
Viewing a List of Interfaces
To view a list of interfaces, type:
show running-config security firewall fwconfig firewall fwinterface
Where firewall is the name of the firewall.
If interfaces have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config security firewall fwconfig fwinterface
security
firewall
fwconfig firewall
fwinterface fe-cm-1
zone man
description Interface
!
!
!
!
If no interfaces have been configured, add interfaces as needed. For more information, refer to Section6.9.10.2,
“Adding an Interface”.

Siemens RUGGEDCOM ROX II Specifications

General

Brand	Siemens
Model	RUGGEDCOM ROX II
Category	Network Hardware
Language	English