Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
Chapter 13
Unicast and Multicast Routing
Viewing a List of IP/VPN Tunnels 567
NOTE
VRF maintains a table listing each interface belonging to each IP/VPN tunnel.
CONTENTS
• Section13.11.8.1, “Viewing a List of IP/VPN Tunnels”
• Section13.11.8.2, “Adding an IP/VPN Tunnel”
• Section13.11.8.3, “Deleting an IP/VPN Tunnels”
Section13.11.8.1
Viewing a List of IP/VPN Tunnels
To view a list of IP/VPN tunnels configured for VRF, type:
show running-config routing bgp address-family vpnv4
A table or list similar to the following example appears:
ruggedcom# show running-config routing bgp address-family vpnv4 | tab
routing bgp
address-family vpnv4
neighbor
SEND
IP COMMUNITY
--------------------
1.2.6.2 both
!
!
Section13.11.8.2
Adding an IP/VPN Tunnel
To add a new IP/VPN tunnel for VRF, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the neighbor by typing:
routing bgp address-family vpnv4 neighbor address
Where:
• address is the IP address of the neighbor
3. [Optional] Set the send community by typing:
send-community [ both | extended | none | standard ]
4. [Optional] Enable the IP/VPN tunnel as a VPNv4 route reflector client by typing:
route-reflector-client enabled
5. Type commit and press Enter to save the changes, or type revert and press Enter to abort.

Siemens RUGGEDCOM ROX II Specifications

General

Brand	Siemens
Model	RUGGEDCOM ROX II
Category	Network Hardware
Language	English