Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
Chapter 12
Tunneling and VPNs
Viewing a List of Remote Daemons 391
Section12.5.5.1
Viewing a List of Remote Daemons
To view a list of remote daemons configured for a GOOSE tunnel, type:
show running-config tunnel l2tunneld goose tunnel name remote-daemon
Where:
• name is the name of the GOOSE tunnel
If tunnels have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config tunnel l2tunneld goose tunnel 1 remote-daemon
tunnel
l2tunneld goose tunnel 1
remote-daemon 192.168.10.2
!
!
!
If no remote daemons have been configured, add daemons as needed. For more information, refer to
Section12.5.5.2, “Adding a Remote Daemon”.
Section12.5.5.2
Adding a Remote Daemon
To configure a remote daemon for a GOOSE tunnel, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the remote daemon by typing:
tunnel l2tunneld goose tunnel remote-daemon address
Where:
• address is the IP address of the remote daemon
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section12.5.5.3
Deleting a Remote Daemon
To delete a remote daemon, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the remote daemon typing:
no tunnel l2tunneld goose tunnel name remote-daemon address
Where:
• name is the name of the GOOSE tunnel
• address is the IP address of the remote daemon
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.

Siemens RUGGEDCOM ROX II Specifications

General

Brand	Siemens
Model	RUGGEDCOM ROX II
Category	Network Hardware
Language	English