Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
Chapter 6
Security
Enabling/Disabling a Firewall 209
2. Set the firewall as the working configuration by typing:
security firewall work-config name
Where:
• name is the name of the firewall configuration
3. Type commit and press Enter to save the changes. The system validates the firewall configuration and
displays the results.
Section6.9.17
Enabling/Disabling a Firewall
To enable or disable the firewall, do the following:
IMPORTANT!
Enabling or disabling the firewall will reset – but not disable – the BFA protection mechanism, if
previously enabled. Any hosts that were previously blocked will be allowed to log in again. If multiple
hosts are actively attacking at the time, this could result in reduced system performance.
1. Make sure the CLI is in Configuration mode.
2. Enable the firewall by typing:
security firewall enable
Or disable the firewall by using the no version of the command:
no security firewall enable
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.

Siemens RUGGEDCOM ROX II Specifications

General

Brand	Siemens
Model	RUGGEDCOM ROX II
Category	Network Hardware
Language	English