Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
Chapter 5
System Administration
Managing Users 111
Where id is the ID for the chosen alarm.
3. Configure the following parameters as required:
NOTE
Depending on the alarm type, some parameters are not available.
NOTE
Alarm descriptions are not configurable.
Parameter Description
severity { severity } Synopsis:  { emergency, alert, critical, error, warning, notice, info, debug }
The severity level can be one of emergency, alert, critical, error, warning, notice, info,
and debug. This cannot be changed for some alarms.
This parameter is mandatory.
admin-enable If disabled, the alarm is not reported in the active list and does not actuate LED/failrelay.
failrelay-enable If enabled, this alarm will assert the failrelay.
led-enable If enabled, the main 'Alarm' LED light will be red when this alarm is asserted. If disabled,
the main 'Alarm' LED light is not affected by this alarm.
auto-clear If enabled, the LED and failrelay will be cleared automatically when condition is met.
4. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section5.8
Managing Users
RUGGEDCOM ROX II allows for up to three user profiles to be configured locally on the device. Each profile
corresponds to one of the following access levels:
• Guest
• Operator
• Admin
The access levels provide or restrict the user's ability to change settings and execute various commands.
User Type
Rights
Guest Operator Admin
View Settings
ü ü ü
Clear Logs
ü ü ü
Reset Alarms
û ü ü
Clear Statistics
û ü ü
Change Basic Settings
û ü ü
Change Advanced Settings
û û ü

Siemens RUGGEDCOM ROX II Specifications

General

Brand	Siemens
Model	RUGGEDCOM ROX II
Category	Network Hardware
Language	English